Tina Linux Mangopi MQ Test Report

Test Environment

Operating System Information

• Download Link: https://mangopi.org/_media/mq-r-f133-rtl8189fs-5113-dns-uart0.zip
• Reference Installation Document: https://mangopi.org/mangopi_mq

Hardware Information

• Mangopi MQ
• A microSD card
• A USB to UART Debugger (e.g., CH340, CH341, FT2232, etc.)

Installation Steps

Flashing Image

Download and extract, then use dd to flash the image to the SD card:

sudo dd if=mq-r-f133-rtl8189fs-5113-dns-uart0.img of=/dev/your/device bs=1M status=progress

Logging into the System

Logging into the system via the serial port.

The board’s TX and RX pins are pins 7, 8 on connector P3, respectively.

Expected Results

The system boots up normally and login through the onboard serial port is possible.

Actual Results

No output from the serial port as the board will always boot into FEL mode for some reason.

Boot Log

Test Criteria

Successful: The actual result matches the expected result.

Failed: The actual result does not match the expected result.

Test Conclusion

Test failed.