Guix System VisionFive 2 Test Report

Test Environment

Operating System Information

Hardware Information

StarFive VisionFive 2
A USB-A Power Adapter
A USB-A to C Cable
A microSD Card
A microSD Card Reader
A USB to UART Debugger (e.g., CH340, CH341, FT2232, etc.)
Three DuPont Wires

Installation Steps

Flashing Image to microSD Card

Use dd to flash the image to the microSD card.

sudo dd if=<hash>-visionfive2-barebones-raw-image of=/dev/your/device bs=1M status=progress

Logging into the System

Log into the system via the serial port.

Username: root No password.

Expected Results

The system should boot normally and allow login via the onboard serial port.

Actual Results

The system booted up successfully, and login via the serial port was successful.

Boot Log

[   36.862330] shepherd[1]: GNU Shepherd 1.0.3 (Guile 3.0.9, riscv64-unknown-linux-gnu)
[   36.870795] shepherd[1]: bit-count is deprecated.  Use bitvector-count, or a loop over array-ref if array support is needed.
[   36.885641] shepherd[1]: scm_bitvector_length is deprecated.  Use scm_c_bitvector_length instead.
[   36.895159] shepherd[1]: Starting service root...
[   36.903053] shepherd[1]: Service root started.
[   36.908134] shepherd[1]: Service root running with value #<<process> id: 1 command: #f>.
[   36.918309] shepherd[1]: Service root has been started.
[   36.935595] shepherd[1]: starting services...
[   36.940596] shepherd[1]: Configuration successfully loaded from '/gnu/store/97s9ywwn93zp2q0i5r892h4aqrs8zp95-shepherd.conf'.
[   37.051971] shepherd[1]: Starting service user-file-systems...
[   37.058551] shepherd[1]: Starting service root-file-system...
[   37.070429] shepherd[1]: Starting service host-name...
[   37.076385] shepherd[1]: Starting service pam...
[   37.086157] shepherd[1]: Starting service sysctl...
[   37.091864] shepherd[1]: Starting service log-rotation...
[   37.102046] shepherd[1]: Starting service loopback...
[   37.107930] shepherd[1]: Service user-file-systems started.
[   37.116275] shepherd[1]: Service root-file-system started.
[   37.122529] shepherd[1]: Service host-name started.
[   37.130024] shepherd[1]: Service pam started.
[   37.135096] shepherd[1]: Service log-rotation started.
[   37.143951] shepherd[1]: Service user-file-systems running with value #t.
[   37.151457] shepherd[1]: Service user-file-systems has been started.
[   37.161530] shepherd[1]: Service root-file-system running with value #t.
[   37.169019] shepherd[1]: Service root-file-system has been started.
[   37.179039] shepherd[1]: Service host-name running with value "visionfive2".
[   37.186839] shepherd[1]: Service host-name has been started.
[   37.195658] shepherd[1]: Service pam running with value #t.
[   37.202150] shepherd[1]: Service pam has been started.
[   37.218602] shepherd[1]: Service log-rotation running with value #<timer #<<calendar-event> seconds: (0) minutes: (0) hours: (22) days-of-month: (1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31) months: (1 2 3 4 5 6 7 8 9 10 11 12) days-of-week: (0)> #<procedure rotation ()> 3f967a48c0>.
[   37.248184] shepherd[1]: Service log-rotation has been started.
[   37.303455] shepherd[1]: Service sysctl has been started.
[   37.309964] shepherd[1]: Service sysctl started.
[   37.424748] udevd[120]: starting version 3.2.14
[   37.480184] udevd[120]: specified group 'sgx' unknown
[   37.545630] udevd[120]: starting eudev-3.2.14
[   37.818554] udevd[120]: no sender credentials received, message ignored
[   37.830806] shepherd[1]: [sysctl] fs.protected_hardlinks = 1
[   37.837502] shepherd[1]: Service sysctl running with value #t.
[   37.850167] shepherd[1]: [sysctl] fs.protected_symlinks = 1
[   37.856627] shepherd[1]: Starting service udev...
[   37.866968] shepherd[1]: could not create '/dev/mapper/control': File exists
[   37.875003] shepherd[1]: waiting for udevd...
[   37.883727] shepherd[1]: Registering new logger for udev.
[   37.890005] shepherd[1]: Service loopback has been started.
[   37.900022] shepherd[1]: [k8s4gfkih3f0icjdqzwk3jaqggp33jf6-set-up-network] Waiting for network device 'lo'...
[   37.910961] shepherd[1]: Service loopback started.
[   37.918228] shepherd[1]: Service loopback running with value #t.
[   38.338893] starfive-dphy-rx 19820000.phy: supply mipi_0p9 not found, using dummy regulator
[   40.496841] starfive-dwmac 16040000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
[   40.506930] starfive-dwmac 16040000.ethernet eth0: PHY [stmmac-1:00] driver [Generic PHY] (irq=POLL)
[   41.521098] starfive-dwmac 16040000.ethernet: Failed to reset the dma
[   41.527605] starfive-dwmac 16040000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed
[   41.536803] starfive-dwmac 16040000.ethernet eth0: __stmmac_open: Hw setup failed
[   41.547218] starfive-dwmac 16030000.ethernet eth1: Register MEM_TYPE_PAGE_POOL RxQ-0
[   41.557443] starfive-dwmac 16030000.ethernet eth1: PHY [stmmac-0:00] driver [Generic PHY] (irq=POLL)
[   42.575157] starfive-dwmac 16030000.ethernet: Failed to reset the dma
[   42.581665] starfive-dwmac 16030000.ethernet eth1: stmmac_hw_setup: DMA engine initialization failed
[   42.590843] starfive-dwmac 16030000.ethernet eth1: __stmmac_open: Hw setup failed
[   42.826381] starfive-dwmac 16030000.ethernet eth1: Register MEM_TYPE_PAGE_POOL RxQ-0
[   42.837799] starfive-dwmac 16030000.ethernet eth1: PHY [stmmac-0:00] driver [Generic PHY] (irq=POLL)
[   42.939653] dwmac4: Master AXI performs fixed burst length
[   42.945234] starfive-dwmac 16030000.ethernet eth1: No Safety Features support found
[   42.952961] starfive-dwmac 16030000.ethernet eth1: IEEE 1588-2008 Advanced Timestamp supported
[   42.963133] starfive-dwmac 16030000.ethernet eth1: configuring for phy/rgmii-id link mode
[   42.974135] 8021q: adding VLAN 0 to HW filter on device eth1
[   42.979914] starfive-dwmac 16030000.ethernet eth1: Adding VLAN ID 0 is not supported
[   43.006705] starfive-dwmac 16040000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
[   43.016906] starfive-dwmac 16040000.ethernet eth0: PHY [stmmac-1:00] driver [Generic PHY] (irq=POLL)


This is the GNU system.  Welcome.
visionfive2 login: [   44.029833] starfive-dwmac 16040000.ethernet: Failed to reset the dma
[   44.036347] starfive-dwmac 16040000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed
[   44.045532] starfive-dwmac 16040000.ethernet eth0: __stmmac_open: Hw setup failed

visionfive2 login: root
This is the GNU operating system, welcome!

root@visionfive2 ~# uname -a
Linux visionfive2 6.13.9-gnu #1 SMP 1 riscv64 GNU/Linux
root@visionfive2 ~# cat /etc/os-release
NAME="Guix System"
ID=guix
PRETTY_NAME="Guix System"
LOGO=guix-icon
HOME_URL="https://guix.gnu.org"
DOCUMENTATION_URL="https://guix.gnu.org/en/manual"
SUPPORT_URL="https://guix.gnu.org/en/help"
BUG_REPORT_URL="https://lists.gnu.org/mailman/listinfo/bug-guix"
root@visionfive2 ~# lscpu
Architecture:             riscv64
  Byte Order:             Little Endian
CPU(s):                   4
  On-line CPU(s) list:    0-3
NUMA:
  NUMA node(s):           1
  NUMA node0 CPU(s):      0-3
Vulnerabilities:
  Gather data sampling:   Not affected
  Itlb multihit:          Not affected
  L1tf:                   Not affected
  Mds:                    Not affected
  Meltdown:               Not affected
  Mmio stale data:        Not affected
  Reg file data sampling: Not affected
  Retbleed:               Not affected
  Spec rstack overflow:   Not affected
  Spec store bypass:      Not affected
  Spectre v1:             Not affected
  Spectre v2:             Not affected
  Srbds:                  Not affected
  Tsx async abort:        Not affected
root@visionfive2 ~# cat /proc/cpuinfo
processor       : 0
hart            : 1
isa             : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb
mmu             : sv39
uarch           : sifive,u74-mc
mvendorid       : 0x489
marchid         : 0x8000000000000007
mimpid          : 0x4210427
hart isa        : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb

processor       : 1
hart            : 2
isa             : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb
mmu             : sv39
uarch           : sifive,u74-mc
mvendorid       : 0x489
marchid         : 0x8000000000000007
mimpid          : 0x4210427
hart isa        : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb

processor       : 2
hart            : 3
isa             : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb
mmu             : sv39
uarch           : sifive,u74-mc
mvendorid       : 0x489
marchid         : 0x8000000000000007
mimpid          : 0x4210427
hart isa        : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb

processor       : 3
hart            : 4
isa             : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb
mmu             : sv39
uarch           : sifive,u74-mc
mvendorid       : 0x489
marchid         : 0x8000000000000007
mimpid          : 0x4210427
hart isa        : rv64imafdc_zicntr_zicsr_zifencei_zihpm_zca_zcd_zba_zbb

root@visionfive2 ~#

Test Criteria

Successful: The actual result matches the expected result.

Failed: The actual result does not match the expected result.

Test Conclusion

Test successful.

System Version

Status

Last Update